Overview
The EcoFlow 220W Lightweight Portable Solar Panel is the most capable panel in the lightweight foldable range, generating approximately 1100Wh per day on average in good conditions. That is enough to keep most mid-to-large portable power stations fully topped up through daily use, making it a genuinely self-sustaining solar setup for freedom camping, motorhome use, and off-grid weekends.
At 5.1kg, it is 46% lighter than EcoFlow's previous 220W Bifacial model and packs down flat for easy transport in a campervan, motorhome, ute, or car boot. The bifacial N-type TOPCon cells deliver up to 25% conversion efficiency and up to 243W output under BNPI conditions, the built-in XT60i-F cable plugs directly into your power station, and the integrated 30 to 60 degree stand and solar angle guide make positioning quick and accurate without extra accessories.
Key Features:
- Rated Power: STC 220W (±5W) / BNPI 243W (±5W)
- Cell Type: N Type TOPCon monocrystalline silicon
- Conversion Efficiency: Up to 25%
- Design: Bifacial (front and rear sides capture light)
- Weight: 5.1kg (±0.3kg)
- Dimensions Unfolded: 2270 x 598 x 26mm
- Dimensions Folded: 603 x 598 x 36mm
- Stand: 30 to 60 degree adjustable, integrated
- Solar Angle Guide: Built in
- Waterproof / Dustproof: IP68 rated panel
- Connector: XT60i-F (built-in cable, approx. 2.5m)
- Open Circuit Voltage: 21.4V (Vmp 18.8V)
- Short Circuit Current: STC 12.2A (Isc) / 11.7A (Imp) | BNPI 13.5A (Isc) / 12.9A (Imp)
What's in the Box?
- 1 x EcoFlow 220W Lightweight Portable Solar Panel with built-in XT60i-F output cable (approx. 2.5m)
- 1 x User Manual / Warranty Card
- Warranty: 5-year warranty
Note: No carry case or separate adapter cable is included. The output cable is built into the panel and uses an XT60i-F connector.

Lightweight, Foldable, and Powerful Enough for Daily Use
At 5.1kg and folding down to fit in a campervan boot, behind a ute seat, or alongside camping gear, the 220W panel is genuinely portable despite its higher output. Generating approximately 1100Wh per day on average in good NZ conditions, it is enough to run a full daily cycle on a mid-to-large power station without needing mains power. Pull it out, unfold it, prop up the integrated stand, plug in the built-in XT60i cable, and start charging.

Bifacial Design Captures More Light
The bifacial design captures sunlight on both the front and rear surfaces of the panel. Set it up on a reflective surface such as light gravel, sand, snow, or a pale tarp and the rear cells pick up reflected and ambient light, pushing total output up to 243W under BNPI test conditions. In real-world NZ conditions, this means you generate more energy per hour of sunlight than a comparable one-sided panel of the same wattage.

25% Conversion Efficiency with TOPCon Cells
The N-type TOPCon monocrystalline silicon cells deliver up to 25% conversion efficiency, which is among the highest available in a portable foldable panel. For NZ users, this means faster top-ups even on overcast or cooler days, where older PERC-technology panels deliver noticeably less power.

Built-in XT60i Cable for a Tidy Setup
The integrated XT60i-F cable stays attached to the panel and folds away neatly when not in use. No loose cables to lose or untangle. When you arrive at camp, pull the cable out, plug it directly into your power station's XT60i input, and start charging. The built-in cable is approximately 2.5m long, giving enough reach to keep your power station in the shade while the panel faces the sun.

30 to 60 Degree Adjustable Stand and Angle Guide
The folding integrated bracket adjusts from 30 to 60 degrees, suited to NZ's mid-latitude sun angles all year round. The built-in solar angle guide helps you position the panel at a 90 degree angle to the sun for maximum output without extra tools or apps.
Not recommended for permanent outdoor mounting or hanging on vehicles long-term. For permanent installations on roofs or walls, use rigid solar panels instead.

IP68 Rated for NZ Weather
With an IP68 rating, the panel surface is fully protected against dust ingress and can handle heavy rain, splashes, and brief immersion. Ideal for unpredictable Kiwi weather, coastal use, beach trips, and bach setups. As with all panels in this range, avoid leaving the junction box and connector area submerged or in standing water.

What's in the Box

Pairs Well with Mid-to-Large Power Stations
The 220W output is well matched to mid-to-large power stations such as the EcoFlow RIVER 3 Max Plus, the EcoFlow DELTA 3 Plus, and the EcoFlow DELTA 3 Max Plus. At approximately 1100Wh per day of average solar generation, it covers a full daily cycle for most use cases without mains power. It is also compatible with most other power stations that accept an XT60i input.
Frequently Asked Questions
How much energy can the 220W panel generate in a day?
In good NZ conditions, the 220W panel generates approximately 1100Wh per day on average. This is enough to run a full daily cycle on most mid-to-large portable power stations without needing to top up from mains power. Actual output varies depending on sunlight hours, cloud cover, panel angle, and time of year.
Should I get the 220W or step up to a 400W panel?
Choose the 220W if you want a portable, easy-to-pack panel that covers a full daily cycle for most mid-sized power stations without mains power. Step up to the 400W if you run a DELTA 3 Max Plus or DELTA Pro 3 daily and want the fastest possible top-up, or if you regularly camp in winter or shaded conditions where extra wattage helps.
What connector does the 220W panel use and how long is the cable?
The panel uses a built-in XT60i-F connector with an integrated cable of approximately 2.5m. It plugs directly into the XT60i solar input port on compatible EcoFlow power stations without needing an adapter. The XT60i connector has three pins (compared to the older two-pin XT60), which allows full solar input current above 8A.
Can I leave the panel set up outside permanently?
No. EcoFlow advises against long-term outdoor mounting, hanging on vehicles, or permanent fixed installations. For roof, wall, or vehicle-mounted setups, use a rigid solar panel instead. The lightweight portable panel is designed to be set up, used, and packed away.
Does the panel come with a carry case or extension cable?
No. The 220W Lightweight panel ships with the panel and its built-in XT60i-F output cable only. There is no carry case, no extension lead, and no MC4 adapter included. EcoFlow has confirmed that no official extension cable is currently available for this panel, so plan your setup around the built-in 2.5m cable. If you need a longer reach, contact us before purchase and we can advise on options.